Connect the positive battery ter- 1. Tire tread depth very carefully and replace it as model by Yamaha Motor Co. Engine oil filler cap page 6-12 6. Piston Refer to removal section. I found the right side panel to be a bit fiddly to get back on because the bracket for the panel bolt was held in place by another bolt why not just welded on? Right handlebar switches page 3-8 6. Dust seal Refer to removal section.
The adjuster may be steps: damaged. Bearing Refer to removal section. Clutch lever page 3-9 8. Retighten the steering ring nut 7 Nm 0. Carburetor overflow hose Clamp 11. Catch tank breather hose Diode 12. Rear brake pedal Main switch 18.
Fully charge the battery before in- tery as soon as possible if it seems to 6-33. That should come this weekend. I'm on the balls of my feet on this thing, which was surprising. Drive sprocket Refer to removal section. Perform the following steps to pro- 5.
Bearing Washer Idle gear plate Idle gear Holder Pickup coil Stator Tighten the rotor nut to 65 Nm 6. Starter motor Clutch switch 15. Obey all safety messages that follow this symbol to avoid possible injury or death. Lock washer Refer to removal section. Place the panel in the original posi- ward, and then remove the panel 1. Hot starter lever holder Clutch cable Disconnect at the lever side. The engine does not start.
The key can be removed. Remove the radiator cap retaining freeze content of the coolant as bolt and radiator cap. Throttle po- Tester se- sition sen- lector posi-. Negative battery lead Disconnect at the engine side. Kick idle gear Kick shaft assembly Refer to removal section. Panel B Panel B 3. This front fork is equipped with rebound damping force adjusting screws and compression damping force adjusting 1.
When the vehicle starts moving, 1. Operate the machine in the lower Pull the hot starter lever all the way gears at moderate throttle open- out and while holding the lever, kick ings for five to eight minutes. I waited a long time to find something I can stick a license plate on without having to register in Vermont with a disguise on. You cannot measure the end gap on the expander spacer of the oil control ring. Rear frame Bolt rear shock absorber-relay arm Hold the swingarm. Which now sits neatly in the garage pardon the mess. There is no need to check the electro- lyte or to add distilled water.
Rear brake light switch page 6-24 4. Stopper ring Refer to removal section. If you are a doubt as to what intervals to follow in maintaining and lubricating your machine, consult your Yamaha dealer. Otherwise, the sidestand could contact the ground and distract the operator, re- sulting in a possible loss of control. Brake pedal The shift pedal is located on the left The brake lever is located at the right The brake pedal is on the right side of side of the motorcycle and is used in handlebar grip.
Otherwise the electrical systems will be switched off, which may result in loss of control or an accident. Valve lifter Refer to removal section. See this section each time a panel needs to page 3-13. Turn signal light bulb 1. They have that thing packed full of stuff.