Feb 26, 2009 My car did past tense the same thing. Twice they put in brand new transmission, 4 times they've dropped out the transmission and took it apart. The truck has been taken to the dealer 6 times. Anyhow good luck, let me know if it did the trick for you. Twice the truck came to a stop where there was no shoulder to get off the roadway. Get your self a new transmission filter and gasket 3.
The transmission won't shift because the converter is plugged. Each time there was a lot of smoke, but no fire. With An All Plastic Transducer Inside Pan on The Passenger Side. With An All Plastic Transducer Inside Pan on The Passenger Side. Truck was fine until i stopped and filled it up, then i noticed if when i got back in. On the third occasion, the vehicle struck the barn and feed trough, causing a broken headlight and a dented bumper.
With 3 pin neutral safety switch. My magnet had usual clutch. If you should need any further information, please feel free to contact me at either number listed. That was at 134,000Km it's now got 210,000 and shifting like a dream. An will also sometimes stick gears an then later when I stop an go again, it's fine.
The truck has to drift to the side of the road. I talked to Dodge about this and they are talking about replacing my transmission. When you push the pedal to the floor the transmission computer holds the transmission in gear. The vehicle was moving at about 5 mph. Meanwhile the engine computer is raising the rpms. The Dodge trucks we wre told have the longest running powertrain capabilities. Does anyone have any clue on what i can do for an easy fix??? The service engine light is flashing until you let off the gas because raw fuel is being dumped into the catalytic converter.
Any information I could get would help. Drop the trans pan and drain all the oil, clean pan and magnet 6. The manufacturer was not contacted. It will seem like a transmission problem but it is more likely a plugged catalytic converter. Posted on Jan 04, 2010 I just had the same trouble with my 96 dodge ram truck 5. Sometimes it will not shift into 3rd gear without slowing down to make it shift. The problem occurred 3 times.
This has happened three times since the truck was new. . I hope this helps I just had the same trouble with my 96 dodge ram truck 5. The manufacturer was not contacted. Engine idled fast, truck took off in reverse and could not be stopped by pressing on the brake. I thought I was going to have to pull it out and get it rebuilt or just replace it.
What I did to solve the problem was this, as follows: 1. The problem occurred 3 times. Justin Posted on Aug 30, 2008 I have a 1996 Dodge ram 1500 Magnum, 5. We feel that they should recall this and have it replaced for no charge to us. This would be normal driving conditions.
No lucas transmission Fix makes things worse. With An All Plastic Transducer Inside Pan on The Passenger Side. It took my transmission about 160 miles of city driving for the Restoring fluid to start working. Speed probably accelerated to 20 mph before hit 3 other vehicles. We were also told that the transmission should not have gone out at 70,000 mi. Witnesses said the rear tires were spinning and the engine noise was high pitched and oscillating. You have a electric shift trans, not a linkage shift.
Now if you have large pieces of metal on the magnet, and it's totally covered in filings, you might want to consider rebuilding the trans. Twice the truck was towed to a dealer and once it stayed together, but was leaking badly. Please give me some advice if Dodge does not fix this problem. A 30,000 dollar truck and only two years old. Says this truck is not included in the recall as does the dealer where it has been repaired.